Connecting and powering the K-TCxx
PreviousInstalling the Rebel DriversNextEnable the AUX Power setting within the Logger Configuration
Last updated
Last updated
However, K-TCxx is powered via the CAN and power connectors and designed with CiA® 102 pinout for the CAN bus and power to connect the device as simply as possible.
Most commonly, it will be powered from a reXgen Air or a Rebel Logger using the Multi Connect Cable or via ReXgen 1/2/IMU via its connectors, but you can also power it via pin 9 (4.5 to 36V) and pin 5 PowerGND of the 9-pin Sub D connectors. If connected via the multi-connect cable, the CAN 1 (MS) bus is also connected, allowing the Logger to record the data transmitted from the K-TCxx.
When using a ReXgen Air device with K-TC, be sure to get in touch with the technical support team at influx.
b) Setup for interfacing Rebel Device to K-TC
Warning:
Several K-TCxx can be daisy chained via the additional DB9 Connector. However, they must have power supplied separately via power breakout in the cable, not via the Logger. It can also connect to other devices, such as the Rebel Dash.
The pinout of the required Cable between the two K-TC 2.0xx is as follows:
