1 of 7

INF4100: Rebel Start-Up Kit Harness

This cable is specifically designed to work with the Rebel 100, making it easier access the data loggerIO during the early engineering development stages.

The Rebel 100 is designed to be installed for long term event monitoring on production machinery and therefore the connector type is the same that you would normally find on an ECU. This type of connector is not very convenient for engineering development since these connectors are harder to work with. The Rebel100 start-up harness will enable you to connect to the Rebel 100 using standard9 PIN D-Sub connectors like the Rebel CT multi-connect cable.

Tech Specs:

Data Logger Socket.

CAN0/CAN1/Kline/PWR Connector

Male 9-pin standard D-type connector with screws

Note:

Pins not mentioned in the description table(s) are NC.

CAN 1 Connector

Female 9-pin standard D-Type connector with screws

Note:

Pins not mentioned in the description table(s) are NC.

CAN 2 Connector

Male 9-pin standard D-type connector with nuts

Note:

Pins not mentioned in the description table(s) are NC.

CAN 3 Connector

Male 9-pin standard D-type connector with nuts

Note:

Pins not mentioned in the description table(s) are NC.

Digital and Analog Connector

Male 15-pin standard D-type connector with screws

Note:

Pins not mentioned in the description table(s) are NC.

INF4100: Rebel Start-Up Kit Harness

This cable is specifically designed to work with the Rebel 100, making it easier access the data loggerIO during the early engineering development stages.