Start-up Guide: ReXgen 1
To download the ReXdesk software
Visit Influx Technology.com >> Support >> ReXgen Series >> Software links>> ReXdesk Download
Windows Search >> ReXgen Drivers >> Select and Install
WARNING:
CAN BUS AND USB ARE NOT ISOLATED.
CARE MUST BE TAKEN WHEN PLUGGING THE USB INTO THE DEVICE. REMOVING THE POWER SUPPLY WHEN THE DEVICE IS INTERFACED WITH A PC VIA USB IS ADVISED.
Notes:
CAN Bus and USB Isolators can be purchased separately.
Please do not use the logger's USB port for data logging, as it may damage the port and will not be covered under warranty.
Connector Details
ReXgen 1 comes with one 9-pin Standard D-Type connector.
PIN No DB9 (Male with Nuts)
PIN Function PWR/CAN0/Digital/LIN
Pin 1
NC
Pin 2
CAN - Low
Pin 3
GND
Pin 4
NC
Pin 5
Power GND
Pin 6
NC
Pin 7
CAN - High
Pin 8
NC
Pin 9
Power Supply 5V to 27V
Warning:
The connector must be tightened securely to connect properly, ensuring reliable operation.
Each end of the CAN bus must be terminated with a 120 Ohm resistor across CAN H & CAN L.
Do not short-circuit any pins.
Do not use the logger's USB port for data logging, as it may damage the USB port, which won't be covered under warranty.
LED 1
Channel 0
Green
LED Patterns
Description
Blinking
Slow- Logging
Fast– CAN Error/Check Connection/Incorrect Baud Rate
Bold– Not logging but configuration active
To update the firmware
Open ReXdesk, connect the logger and click the ‘Reflash’ option under the Device tab.
Reflash – Select the required firmware to update the logger.
Notes:
Do not disconnect the logger until the logger LED stops flashing. The logger will automatically reconnect to the software after reflashing.
Please ensure that the internal storage is formatted after reflashing the logger.
To set the time
Open ReXdesk, connect the logger and click ‘Set Time’ on the top taskbar.
To synchronise the logger’s time with your PC, select ‘Synchronise with PC.
Or
To manually set the logger’s time, select ‘Set Custom Date Time’.
Click ‘Set Time” to save.
Notes:
If you see the logger logging with the wrong timestamp, check the RTC battery.
Click for instructions on turning on the battery.
To start logging
Open ReXdesk, connect the logger, double-click or drag and drop the ‘Log All’ icon into the configuration window.
Click the ‘Run’ icon on the top taskbar and save the project.
Once the Configuration is uploaded successfully, click OK.
How to set up a ReXgen datalogger.
To open logged data from internal storage
Click the Internal Storage tab, then select the file you wish to open.
Click the Download tab, then select the required format for download.
Warning:
Always ensure the device is installed, connected, and commissioned by a qualified professional.
The device must only be repaired by the manufacturer.
Please do not use the logger's USB port for data logging, as it may damage the port and will not be covered under warranty.
Last updated