PinOut Details

PIN DETAILS:

There are two connectors, a male and female 9-pin Standard D-Type connector.

Channel 0 Connector

PIN No DB9(Male with Nuts)	PIN Function PWR/CAN0/Digital/LIN
Pin 1	Digital 1
Pin 2	CAN/CAN FD 0 - Low
Pin 3	GND
Pin 4	LIN
Pin 5	Power GND
Pin 6	Digital 0
Pin 7	CAN/CAN FD 0 - High
Pin 9	Power Supply 5-31V

Channel 1 Connector

PIN No DB9(Female with Screws)	PIN Function CAN1/Clamp/Analog
Pin 1	GND A
Pin 2	CAN/CAN FD 1-Low
Pin 3	GND
Pin 4	Analog IN 0
Pin 5	GND A
Pin 6	Analog IN 1
Pin 7	CAN/CAN FD 1-High
Pin 8	Clamp-15

Notes:

• The connector needs to be tightened properly to ensure a reliable connection and proper operation.

• Each CAN/CAN FD bus end must be terminated with a 120Ω resistor across CAN H & CAN L.

• Do not short-circuit any pins.

• The maximum safe applied voltage for analog and digital I/P is ± 28 V.

• Please do not use the logger's USB port for stand-alone data logging, as this may damage the port and will not be covered under warranty.