INF2213
Our K-IEPE module is designed to connect IEPE sensors to a K-Box or K-AN8 voltage measurement device that normally cannot support IEPE sensors.
The powered K-IEPE module simply enables IEPE sensors to be connected via the BNC terminals and will output the signal voltages to the analog measurement device.
Calibration and sampling rates can be configured using the freely distributed K-Cal software.
Connects to the K-Series K-Box/K-AN8 via the Analog inputs
Refresh rates achievable (4 channels 1kHz)
ABS enclosure
Wide frequency range
Linear amplitude characteristics in a wide dynamic range
Ability to operate in severe ambient conditions (temperature, humidity, radiation and magnetic fields)
High mechanical reliability and durability at the expense of moving parts in the sensor
High vibration and shock resistance
No need for other power supplies for sensors
Compact structure and a large ratio of sensitivity to mass
Measurement inputs
4
Internal resolution
18 bit
Internal sampling rate per ch.
6.25kHz
Measurement data rate per ch.
4 channels: 1kHz. CAN bus: 1Mbit/s
SW input filter
A digital filter in the ADC module is automatically adjusted to the sampling rate
High pass filter
13.8Hz
Bandwidth
21.8Hz
Operational safety
-0.7V to +24V permanent, additional
Device safety
-0.7V to +24V permanent, additional ESD protection
Input impedance
>10K
Broken sensor detection
Yes
Typical SNR @ 30kHz Band Width
Sampling @6.25Hz: 102dB
Linearity
ADC ±0.75 LSB
Current source
5.1mA ± 2%
Voltage
24V
Output power
Maximum total (for 4 channel) current: 60mA
Channel/ power supply Isolation
1000 VDC minimum
Sensor excitation/ power supply Isolation
1000 VDC minimum
CAN channel Isolation
1000 VDC minimum
CAN power supply Isolation
CAN and power are galvanically connected
Configuration
Configuration with K-Box Cal application by company protocol
Power supply
4.5V to 36V DC.
Power consumption
Typ. 2.6W
Housing
ABS
Dimensions/ Weight/ Protection Class
D: (128x46x105mm); W: 450g; PC: IP65
CAN/ Power supply
Two 9-pin D-Type connections with duplicate signals
Signal Inputs
BNC Connector
Operating temperature range
-40degC to +85degC