ReXgen Air

There are two connectors, a 24-pin Molex Mini50 connector and a male 25-pin Standard D Type connector

PCB Header

Mating Connector Details

Terminals

1MB

ReXgen Air_V1.2.pdf

pdf

24-pin Molex Mini50 Connector

PIN No	PIN Function	Optional
Pin 1	RelayOut0	Relay Driver
Pin 2	DigIn0
Pin 3	AnalogGnd
Pin 4	Adc1
Pin 5	Clamp-15
Pin 6	CAN0-L
Pin 7	CAN1-L
Pin 8	CAN2-L	Additional CAN FD 3rd bus
Pin 9	CAN3-L	Additional CAN FD 4th bus
Pin 10	usbDP_conn	Request when ordering
Pin 11	4.5Vout
Pin 12	DIgIn1
Pin 13	Adc0
Pin 14	Erase#
Pin 15	LIN
Pin 16	GND
Pin 17	PowerGND
Pin 18	5V to 27V
Pin 19	CAN0-H
Pin 20	CAN1-H
Pin 21	CAN2-H	Additional CAN FD 3rd bus
Pin 22	CAN3-H	Additional CAN FD 4th bus
Pin 23	usb5V	Request when ordering
Pin 24	usbDM_conn	Request when ordering

Male 25-pin Standard D Type connector (Mini 50 to D Sub 25 cable Sold separately).

Pin No	Pin Function
Pin 3	CAN Bus 3 Low Signal (Available only on 4x CAN Model)
Pin 4	Analog Input 1 - do not apply voltages outside of the -10 to +10V range
Pin 5	Wake-Up pin to wake logger from sleep mode (Appendix 1)
Pin 6	CAN Bus 1 Low Signal
Pin 7	CAN Bus 0 Low Signal
Pin 9	+5V to +27V Supply Voltage
Pin 10	+4.5V Instrumentation Supply Voltage, ensure that current draw is not more than 100mA
Pin 11	Erase PIN
Pin 12	Digital Input 0 - When used as an input, do not apply voltages outside the 0 to +12V range. More information on the use of this pin can be found in Appendix 2
Pin 13	CAN Bus 2 Low Signal (Available only on 4x CAN Model)
Pin 15	LIN 0 Signal
Pin 16	CAN Bus 3 High Signal (Available only on 4x CAN Model)
Pin 17	Analog Input 0 - do not apply voltages outside of the -10 to +10V range
Pin 18	Analog Ground
Pin 19	CAN Bus 1 High Signal
Pin 20	CAN Bus 0 High Signal
Pin 21	Ground
Pin 22	Power Ground
Pin 23	Relay Out (Optional Feature)
Pin 24	Digital Input 1 - When used as input, do not apply voltages outside the 0 to +12V range More information on the use of this pin can be found in Appendix 2
PIN 25	CAN Bus 2 High Signal (Available only on 4x CAN Model)

Notes:

• The connector needs to be tightened properly to make a proper connection, ensuring reliable operation.

• Each end of the CAN bus must be terminated with a 120 Ohm resistor across CAN H & CAN L.

• Do not short-circuit any pins.

• The maximum safe applied voltage for analogue and digital I/P is ±28 V.

Attention:

• To set up a USB via the Molex connector, please specify this requirement when ordering, or the device must be sent back to Influx (as this requires some hardware modification).