Record Raw CAN Bus data

Begin creating a configuration by clicking the 'New Configuration' tab under the 'Configuration' tab.

Name the configuration and then click 'OK'.

While performing this step, check the sleep mode settings to avoid battery drain.

• Use the drop-down menu to select the required mode.

• Ensure that the 'Limit Module Wakeup' is not enabled, and then select 'OK'.

Select the 'New Bus' tab.

Select CAN 0 (HS), and select 'OK'.

Select the drop-down CAN /bus speed menu, allocate the correct bus speed that matches your CAN network requirement, and then select 'OK'.

Click on 'New Protocol'.

Select 'CAN Monitor' from the displayed choices, and click 'OK'.

Enable the check box before 'Log All Channels' to enable full CAN log trace, and click 'OK'.

The configuration has been successfully made.