LogoLogo
Home
  • 🏠Home
  • StreamLog User Documentation
    • Quick Start Guide
      • DiaLog Configuration
        • Accessing StreamLog
      • Software Introduction
        • Toolbar
        • Filter Panel
        • Projects Panel
        • Editors Tabs
      • StreamLog Set Up
        • StreamLog Settings
          • Assigning Engineers, Vehicles and Loggers
        • Fleet Parameters
      • Rebel Set Up
        • GPRS settings
        • WiFi Settings
      • StreamLog Operation
        • Editors Tabs
          • Sessions Tab
          • Loggers Tab
          • Vehicles Tab
          • Events Tab
          • Engineers Tab
          • Live View Tab
          • Fleet Overview Tab
          • Fleet Reports Tab
        • Data Extraction from StreamLog
          • Extracting streamed data
          • Requesting IVD data from Logger
        • Updating a Configuration of an assigned Rebel
        • Reports
      • Appendix
        • User Administration
        • User Workflow
    • StreamLog Initialisation- User Guide
    • SIM Card Installation Guide
    • StreamLog Assistant
      • DiaLog Configuration
        • Checking communication between DiaLog and the StreamLog Server
      • Rebel Set-Up
        • GPRS settings
        • Checking communication between the Rebel (GPRS) and the StreamLog Server
        • WiFi Settings
        • Checking communication between the Rebel (WiFi) and the StreamLog Server
Powered by GitBook
On this page
Export as PDF
  1. StreamLog User Documentation
  2. StreamLog Assistant
  3. Rebel Set-Up

Checking communication between the Rebel (WiFi) and the StreamLog Server

PreviousWiFi Settings

Last updated 1 year ago

The communications between the Rebel (WiFi) and the StreamLog server can be tested by running the StreamLog Connection Assistant on the PC where DiaLog is installed; once you launch the Application, you can see a diagram representing the configuration you wish to use.

Once you are ready press the Check WiFi Connection button to test the Connection between the Rebel (WiFi) and the StreamLog Server.

You will be asked to plug the Logger in and ensure that 12V is supplied via the OBD Connector.

After confirming,

you will see the WiFi connection is started and the Rebel will log into the access point as with the PSK security settings it is configured to use.

The following shows successful communication between the Rebel (GPRS) and the StreamLog Server.