Rebel Data Logger Connector

Female 25-pin standard D-Type connector with screws

Female 25-pin standard D-Type connector

Pin No	Pin Function
Pin 1	Analog Input 3 - do not apply voltages outside of the -10 to +10V range
Pin 2	LIN 1
Pin 3	CAN/CAN FD 3 L
Pin 4	Analog Input 1 - do not apply voltages outside of the -10 to +10V range
Pin 5	Wake-Up pin to wake logger from sleep mode (for use see Appendix 1)
Pin 6	CAN Bus 1 (Medium Speed Bus) Low Signal
Pin 7	CAN Bus 0 (High Speed Bus) Low Signal
Pin 8	K-Line (1 wire bus) of ISO 9141
Pin 9	4.5-36V Supply Voltage
Pin 10	+4.5V Instrumentation Supply Voltage, ensure that current draw is not more than 100mA
Pin 11	Digital Input or Output 2 - When used as an input do not apply voltages outside of the 0 to +12V range, when used as an Output ensure that current draw is not more than 100mA. More information on use ofthis pin can be found in Appendix 2 and 3
Pin 12	Digital Input or Output 0 - When used as an input do not apply voltages outside of the 0 to +12V range, when used as an Output ensure that current draw is not more than 100mA. More information on use ofthis pin can be found in Appendix 2 and 3
Pin 13	CAN/CAN FD Bus 2 (Instrumentation Bus) Low Signal
Pin 14	Analog Input 2 - do not apply voltages outside of the -10 to +10V range
Pin 15	LIN 0
Pin 16	CAN/CAN FD 3 H
Pin 17	Analog Input 0 - do not apply voltages outside of the -10 to +10V range
Pin 18	Analog Ground
Pin 19	CAN Bus 1 (Medium Speed Bus) High Signal
Pin 20	CAN Bus 0 (High Speed Bus) High Signal
Pin 21	Ground
Pin 22	Power Ground
Pin 23	Digital Input or Output 3 (can also be used as a switched power supply +Vd)
Pin 24	Digital Input or Output 1 - When used as an input do not apply voltages outside of the 0 to +12V range, when used as an Output ensure that current draw is not more than 100mA. More information on use ofthis pin can be found in Appendix 2 and 3
Pin 25	CAN/CAN FD Bus 2 (Instrumentation Bus) High Signal

WARNING

DO NOT SHORT CIRCUIT OR OVERLOAD ANY DIGITAL I/O e.g. IF USING DIGITAL INPUT OR OUTPUT 3 TO SUPPLY POWER TO A K-BOX OR A REBEL DASH, DO NOT CONNECT MORE THAN 1 K-BOX TO THIS OUTPUT AND BE CAREFUL THAT NO SHORT-CIRCUIT OCCURS.

WARNING

DO NOT SHORT CIRCUIT OR OVERLOAD PIN10 (+4.5V INSTRUMENTATION)