LogoLogo
Home
  • 🏠Home
  • Rebel Dash
    • Rebel Dash: Product Manual
      • Connecting the Rebel Dash to a CT or LT Logger
      • Technical Specifications
      • The Rebel Dash Software
        • Installing the Rebel Dash Config Software
        • Configuring the Rebel Dash using the Rebel Dash Software
          • Creating a Configuration Ready to send to the Rebel Dash
          • Installing the Kvaser Drivers
          • Sending the Configuration via the CAN bus through a Kvaser Device
          • Sending the Configuration via USB stick
        • Updating the Firmware in the Rebel Dash
      • Configuring the Rebel Dash using DiaLog
      • Using the Rebel Dash to Display the Signals
        • Config Menu
          • CAN Viewer
        • Changing between Signals
        • Changing the Display Mode
      • Pinout Details: Rebel Dash
        • Pinout of the Rebel Dash Cable
        • Pinout of the OBD2 to DB9 Cable
        • Pinout of the Multi Connect Cable
Powered by GitBook
On this page
Export as PDF
  1. Rebel Dash
  2. Rebel Dash: Product Manual
  3. Pinout Details: Rebel Dash

Pinout of the OBD2 to DB9 Cable

PreviousPinout of the Rebel Dash CableNextPinout of the Multi Connect Cable

Last updated 1 year ago

The Standard Display Cable may be connected to the optional DB9 to OBD2 Cable for direct connection to the Diagnostics CAN bus and power in a vehicle. The pinout of that cable is as follows:

DB9

Pin Function

Pin 2

CAN L

Pin 3

Ground

Pin 5

Ground

Pin 7

CAN H

Pin 9

Power Supply 10-32V

OBD2

Pin Function

Pin 4

Ground

Pin 5

Ground

Pin 6

CAN H

Pin 14

CAN L

Pin 16

Battery Power

Note:

  • Pins not mentioned in the description table(s) are NC.

Female 9-pin Standard D-Type Connector
Standard OBD2 connector