LogoLogo
CtrlK
Home
  • 🏠Home
  • Rebel Dash
    • Rebel Dash: Product Manual
      • Connecting the Rebel Dash to a CT or LT Logger
      • Technical Specifications
      • The Rebel Dash Software
        • Installing the Rebel Dash Config Software
        • Configuring the Rebel Dash using the Rebel Dash Software
          • Creating a Configuration Ready to send to the Rebel Dash
          • Installing the Kvaser Drivers
          • Sending the Configuration via the CAN bus through a Kvaser Device
          • Sending the Configuration via USB stick
        • Updating the Firmware in the Rebel Dash
      • Configuring the Rebel Dash using DiaLog
      • Using the Rebel Dash to Display the Signals
        • Config Menu
          • CAN Viewer
        • Changing between Signals
        • Changing the Display Mode
      • Pinout Details: Rebel Dash
        • Pinout of the Rebel Dash Cable
        • Pinout of the OBD2 to DB9 Cable
        • Pinout of the Multi Connect Cable
Powered by GitBook
On this page
Export as PDF
  1. Rebel Dash
  2. Rebel Dash: Product Manual
  3. The Rebel Dash Software

Installing the Rebel Dash Config Software

To begin the software installation, double-click the Rebel Dash Config setup icon to proceed.

A pop-up will appear for the verification of installing the software. Click 'Run' to confirm the installation of the software.

Wait till the installation is finished.

  • Enable the 'Launch the program' checkbox by clicking on it.

  • Click 'Finish' to launch the software.

How to install the configuration software for Rebel Dash.

PreviousThe Rebel Dash SoftwareNextConfiguring the Rebel Dash using the Rebel Dash Software

Last updated 1 year ago