Periodic CAN/CAN FD Transmission

• Create a new project.

• Drag and drop the ‘Periodic Transmission’ tool to the ‘Output’ area of the configuration window.

• If you have not configured the same in the logging area, click the CAN bus icons and set the CAN bus properties.

*Users can use the ‘Bit Timing’ option for advanced configurations.

• In the periodic messages window,

  • Add: This allows the user to add the messages to be transmitted.

  • Remove: This allows the user to delete unwanted messages.

  • Link Message UP: This allows the user to link one/multiple messages to the previous message.

  • Unlink: This allows the user to unlink one/multiple messages from the previous linked message.

  • Move Up: This allows the user to move a specific, unlinked configuration upward.

  • Move Down: This allows the user to move a specific, unlinked configuration downwards.

  • Load From Cloud: This allows the user to Load the configuration from the Cloud.

  • Save CSV: This allows the user to save the periodic messages in CSV format.

  • Load CSV: This allows the user to load the periodic message in CSV format.

  

Users can enter the following information:

• Ident: Message Identifier

• Linked: Know if the message is linked.

• Period: Specify the Period of transmission.

• Delay: Specify the delay in transmission.

• CAN 0/CAN 1/CAN 2/CAN 3: Option to choose the transmission bus.

• Type: Specifies the type of CAN message (CAN/CAN FD) (Standard/Extended).

• BRS: Bit Rate Switch.

• DLC: Data Length Code (0-64).

• Data

How to configure Periodic Message Transmission in ReXgen.