Enable the AUX Power setting within the Logger Configuration

If you power it from the Logger, the Logger will need to be powered from the vehicle or an external power source

(NOT just via USB) and you will need to make sure the AUX power feature in the configuration is set to on. To do this, follow the Steps Below:

Right-click on the Project that you want to configure and select ‘Properties’; if you need to create a configuration, this is detailed in the ‘Loading the K-TCxx configuration into DiaLog’ section document.

Once the Edit Configuration window is displayed, click on the ‘Settings’ Tab and put a Checkmark in Aux Power On.

Click OK to set the Aux Power on Setting in the Configuration…

Send the configuration to the Logger by right-clicking on the project and choosing “Send Configuration to the Logger.”

If you have the CAN bus that the K-TCxx is connected to set to the right speed within your Project, you will see the Status Light on Solid Orange, and the CAN Light on Solid Green; if it is flashing green, the CAN bus is misconfigured, check the speed and termination.