Enable the AUX Power setting within the Logger Configuration

If you power it from the Logger, the Logger will need to be powered from the vehicle or an external power source.

(NOT just via USB) and you will need to ensure the AUX power feature in the Configuration is set to “On”. To do this, follow the Steps Below:

Right-click on the “Project” you want to configure and select “Properties”. If you need to create a configuration, this is detailed in this document's ‘Loading the K-Box configuration into DiaLog’ section.

Once the Edit Configuration window is displayed, click the “Settings” tab and put a checkmark in Aux Power On.

Click “OK” to set the Aux Power on Setting in the Configuration.

Send the Configuration to the Logger by right-clicking on the “Project” and choosing “Send Configuration to the Logger.”

Notes:

• Within the 'Project', you should have the bus that the K-Box is connected to set as CAN 1 (MS) if you are using the AUX connector of the Multi Connect Cable.

If you have the CAN bus that the K-Box is connected to set to the correct speed within your project, you will see the Status Light on Solid Orange and the CAN Light on Solid Green. If it is flashing green, the CAN bus is misconfigured; check the speed and termination.