Measurement IEPE procedure

1. Connect the K-Box and IEPE devices. Connect the IEPE sensors to the IEPE0-3 channel.

2. Set the Additional board to Not Connected, Software ranges of odd channels to ±20V.

1. Connect the IEPE sensors, Keep the sensor in idle conditions, and Go to measurement mode.

Note down the measured value for ADC1 (IEPE 0), ADC3 (IEPE 1), ADC5 (IEPE 2) and ADC7 (IEPE 3) channels in mV.

IEPE & Analog channel links: ADC1-IEPE0, ADC3-IEPE1, ADC5-IEPE2, ADC7-IEPE3

1. Go to the Analog channel tab. Change the Additional board to IEPE, copy remembered values to the Offset edit box of each IEPE channel, and enter the sensitivity of the sensors.

1. Go to Measurement mode.

Then, export the DBC and import it into DiaLog software.

Make sure you select the combined option in the IEPE Transmit – Measure option.