Pulse Duration Measurement

To measure Pulse duration, select Pulse duration in the drop-down box:

Also, set the CAN ID rate, where The K Box will transmit the result.

Set the Rate you wish to measure at:

Select the edge on which you wish to start measuring the pulse duration.

The KBox will not send CAN messages (although the rate is met) until the required measurement is finished.

The KBox will re-calculate the message and Rate to prevent CAN bus overloading.

Examples:

Pulse frequency: 2000Hz (0.5ms). Rate: 50ms. CAN bus Speed: 125 kbps.

If there is no overloading of the CAN bus, a corresponding CAN Message will be sent every 50ms.

Pulse frequency: 2000Hz (0.5ms). Rate: 1ms. CAN bus Speed: 125 kbps.

If there is no overloading of the CAN bus, a corresponding CAN Message will be sent every 2ms.